Speak to Live Agent 1-800-813-8599

Sign in
In Cart ()
Etlin-Daniels

Etlin-Daniels CNM6 Microwave Motion Sensor

CA$36.55
In stock
SKU
T-7515
Model: CNM6-SENMC-12V |Microwave motion sensor |12–24V DC |0–10V dimming |IP65 |For CNM6 canopy light

This optional microwave motion sensor plugs into the factory-installed sensor base on the CNM6-M80WC0-SB-BL canopy light. It adds motion-based control for suitable garages, covered entrances and circulation areas, allowing the fixture to move between full output, a standby dimming level and off according to the configured settings.

Disconnect power, remove the plug from the fixture sensor receptacle and fit the sensor as shown in the CNM6 installation instructions. The sensor operates from the compatible low-voltage interface at 12–24V DC and provides a 0–10V dimming signal; it must not be connected directly to line voltage. The maximum mounting height listed for this microwave version is 15 m / 50 ft.

The microwave detector uses a 5.8GHz signal with transmission power below 0.2mW. Its adjustable detection area is listed as 1–8 metres, subject to sensitivity selection and installation conditions. Initial warm-up is 15 seconds.

IP65 protection and a stated operating range of -20°C to 60°C apply to the sensor. Check both the sensor and host fixture limits for the installation. The canopy light and CNM6-RC programming remote are separate products. This accessory does not provide emergency battery backup.

More Information
Brands Etlin-Daniels
MPN ( Part No.) CNM6-SENMC-12V
Voltage 12–24V DC
Feature 0–10V dimming;IP65;maximum mounting height 15 m / 50 ft;operating -20°C to 60°C; Product: Microwave motion sensor
Pack Quantity 1
Write Your Own Review
You're reviewing:Etlin-Daniels CNM6 Microwave Motion Sensor
Your Rating