Speak to Live Agent 1-800-813-8599

Sign in
In Cart ()
Etlin-Daniels

Etlin-Daniels CNM6 PIR Motion Sensor

CA$36.55
In stock
SKU
T-7516
Model: CNM6-SENPIR-12V |PIR motion sensor |12–24V DC |0–10V dimming |IP65 |For CNM6 canopy light

This optional pir motion sensor plugs into the factory-installed sensor base on the CNM6-M80WC0-SB-BL canopy light. It adds motion-based control for suitable garages, covered entrances and circulation areas, allowing the fixture to move between full output, a standby dimming level and off according to the configured settings.

Disconnect power, remove the plug from the fixture sensor receptacle and fit the sensor as shown in the CNM6 installation instructions. The sensor operates from the compatible low-voltage interface at 12–24V DC and provides a 0–10V dimming signal; it must not be connected directly to line voltage. The maximum mounting height listed for this pir version is 12 m / 40 ft.

The PIR detector responds to movement within its coverage pattern and includes the daylight-control function described in the CNM6 manual. Initial warm-up is 40 seconds. The remote-control instructions state that PIR sensitivity is not adjustable; do not select this version on the assumption that the microwave sensitivity settings also apply.

IP65 protection and a stated operating range of -20°C to 60°C apply to the sensor. Check both the sensor and host fixture limits for the installation. The canopy light and CNM6-RC programming remote are separate products. This accessory does not provide emergency battery backup.

More Information
Brands Etlin-Daniels
MPN ( Part No.) CNM6-SENPIR-12V
Voltage 12–24V DC
Feature 0–10V dimming;IP65;maximum mounting height 12 m / 40 ft;operating -20°C to 60°C; Product: PIR motion sensor
Pack Quantity 1
Write Your Own Review
You're reviewing:Etlin-Daniels CNM6 PIR Motion Sensor
Your Rating