This microwave sensor kit adds occupancy and daylight-responsive control to a compatible HBRA7 round highbay. It includes the mounting bracket and watertight connection identified on the manufacturer product page. The sensor operates on 10–15V DC and provides a 0–10V dimming signal; it is not connected directly to the branch-circuit voltage.
The sensor supports detection-area settings of 25%, 50%, 75% and 100%, hold times from five seconds to 30 minutes, and standby dimming levels of 10%, 20%, 30% or 50%. Its daylight threshold can be set to 2, 10, 30, 50, 80 or 120 lux, or disabled. Standby periods range from off after the hold time to a continuous standby setting.
The installation guide shows the sensor secured at the centre of the fixture using four screws, with the low-voltage cable routed through the heatsink to the rear connection. Seal the watertight connector correctly. The guide illustrates typical ceiling mounting at 15 metres; actual coverage depends on mounting height, sensitivity and movement.
This sensor is for indoor applications. The guide excludes spaces with all-metal walls or metal roofing and cautions against installation near moving or vibrating machinery and ceiling fans. It specifies IP65 protection, operation from -20°C to 60°C and a five-year warranty. Configure the exact sensor using the separately sold HBRA7-RC remote; the highbay fixture is also separate.
| Brands | Etlin-Daniels |
|---|---|
| MPN ( Part No.) | HBRA7-SENMC-KIT |
| Voltage | 10–15V DC |
| Feature | Microwave detection;0–10V output;30mA±5%;standby≤0.5W;IP65;-20°C to60°C;5-year sensorwarranty;mountingbracket andwatertightconnectionincluded; Product: Sensor |
| Pack Quantity | 1 |