This white PIR occupancy sensor adds on/off control to compatible high and low bay luminaires. The same lens supports mounting heights from 8ft to 40ft with a 360-degree detection pattern, making it suitable for different ceiling heights in indoor and outdoor installations that meet the fixture and sensor conditions.
Mount the sensor through the luminaire 1/2-inch knockout, keep its lens facing the required detection area, and make ingress-protected connections to preserve wet-location suitability. It operates on 120–347V AC at 50–60Hz. This O version provides line-voltage switching; it is not the separate D version with a dimming output.
DIP switches select 50% or 100% sensitivity and a hold time from 10 seconds to 20 minutes. The daylight setting can restrict operation to darker conditions or be disabled. Allow the initial 40-second warm-up and use a short delay for walk testing. Actual detection depends on mounting height, movement and site conditions.
Load ratings depend on the load type. The specification lists halogen loads of 800W at 120V, 1200W at 277V and 1500W at 347V; fluorescent/CFL ballasts are rated 660VA, 1200VA and 1500VA respectively. Electronic ballast and LED-driver loads are limited to 5A at each listed voltage. There is no minimum load requirement.
The sensor measures 97.5 x 81 x 44 mm and operates from -40°C to 75°C with a maximum 95% relative humidity. The luminaire and installation hardware are separate. No independent warranty term is published in the reviewed sensor specification or installation guide.
| Brands | Etlin-Daniels |
|---|---|
| MPN ( Part No.) | SENPIR-HLB-O |
| Voltage | 120–347V AC |
| Feature | PIR on/off;wet location;360°;8–40ft mounting height;1/2in knockout;50%/100% sensitivity;10s–20min hold;daylight enable/disable;LED driver max5A;97.5x81x44mm;-40°C to75°C;max95%RH;0.5W@120V / 0.7W@277V / 0.9W@347V; Product: Sensor |
| Color | White |
| Pack Quantity | 1 |