Reno OPS LED Architectural Slim Full Cut-off Wall Pack R3 - Black

Reno identifies the 3000K configuration for dark-sky applications. For an exterior wall near homes or walkways, check the fixture aiming and light distribution before installation.

The Reno OPS LED Architectural Slim Full Cut-off Wall Pack R3, model RENO-SFWP-DV-MCCT-ABA-G2-R3-BK, is specified at 90/120/150W, 3-CCT. Order this version under R51214. Consider this model for a commercial façade when lighting coordinated with doors and adjacent routes is part of the lighting plan and the model’s installation conditions are satisfied.

For this model, coordinate the wall connection and fixture orientation with the entrance or route below it. The full cut-off form of this model makes fixture orientation important when directing light below the wall position. Use the 120-347V version only where the supply and control arrangement suit its electrical specification. With 3K/4K/5K available, the same model can be set to the colour appearance chosen for the installation. Follow the model instructions when changing settings. The 90/120/150W power settings allow output to be selected for the layout; use the lower or higher setting according to the task, not a fixed rule for room names. Use the 0-10V control interface for dimming; the power circuit alone does not provide the separate dimming signal.

For RENO-SFWP-DV-MCCT-ABA-G2-R3-BK, refer to the manufacturer’s specification sheet and installation instructions for the detailed dimensions and installation requirements.

Buying tip: Select the 3000K configuration for a dark-sky project and verify the mounting and shielding conditions before ordering.