This passive-infrared occupancy sensor switches and dims compatible lighting according to movement and daylight. Its high- and low-bay lens supports 8–40ft mounting heights, making it suitable for compatible warehouse, retail and work-area luminaires where unattended lighting should reduce after occupants leave.
The sensor operates from 120–347V and connects to a compatible 0–10V dimming driver or ballast. Confirm the actual load type and driver compatibility: the electronic LED-driver rating is 5A at each listed voltage, while halogen and fluorescent loads have separate ratings. The sensor is not a microwave detector.
Mount through a suitable luminaire half-inch knockout and make all supply, load and dimming connections with power disconnected. The wet-location rating applies only when the installation maintains proper ingress protection at the connections. Allow approximately 40 seconds for initial warm-up, then perform a walk test before selecting final coverage and timing settings.
Built-in DIP switches provide sensitivity, daylight threshold, standby level and timing settings, including a 10-second to 15-minute hold-time range. The optional RC-SENPIR-HLB remote extends programming options, including hold times up to 60 minutes and stored profiles. The remote is sold separately; it is not required for basic DIP-switch operation.
| Brands | Etlin-Daniels |
|---|---|
| Product | Sensor Switch |
| MPN ( Part No.) | SENPIR-HLB-D |
| Wattage | LED driver 5A at120/277/347V;halogen800/1200/1500W respectively;fluorescent660/1200/1500VA respectively |
| Input Voltage | 120–347V AC;50–60Hz |
| Feature | PIR 360°;8–40ft mounting;0–10V max25mA sinking;half-inch knockout;no minimum load;power0.5/0.7/0.9W at120/277/347V;DIP hold10s–15min;remote hold10s–60min;remote sold separately |
| Color | White |
| Rating | Wet location with protected connections;cULus Listed |
| Pack Quantity | 1 |
| Length | 3.84 inches / 97.5mm |
| Height | 1.74 inches / 44mm |
| Width | 3.2 inches / 81mm |